iFlight XING2 1806 1600KV/2500KV 4-6S FPV Brushless Motor

• Our XING series of NextGen engines gained popularity after the first release in 2018 and became the new standard in the market. Was it the curved shape or the internal damping ring to protect the bearing, or was it the higher quality NSK bearings combined with a high quality titanium alloy shaft? We've been copied and compared all these years, but now it's time to set a new standard again! We're finally ready to announce our predecessor the XING2!
• The smooth, reliable and powerful XING engines were upgraded and we achieved an even higher standard in our factory and better performance than ever before. New N52H Center Slot Curved Arc Magnets were introduced to dramatically reduce motor response time! Perhaps the biggest bottleneck of our FPV flight controller is the motor due to the translation delay when braking and accelerating. XING2 motors provide a faster response to translate your PID loop faster and get that locked-in feeling you've always been looking for!
• The high-quality materials used and the durable connection of bell and shaft allowed us to keep the air gap of the magnet and stator lamination to a minimum. The smaller the air gap, the lower that reluctance and the higher the magnetic flux (which is the magnetic analog of current), causing more efficiency and more power!
• In early 2018 we started putting o-rings on top of our bearings between the motor bell and stator. This acts as an absorber if your bell or shaft has crashed and keeps the bearing gap tight to reduce all that vibration caused by high RPMs! It can also reduce axial impact force just enough to keep your bearings smooth and quiet. All our experience, high quality 7075 bells, O-ring bearing protection and all the other features you just saw on your original XING series are still built into a new shape and design!

• 1.5mm titanium alloy outer shaft
• Japanse NSK φ7*φ3*3mm lagers
• N52H curved magnets
• Motor wires protected
• Dynamically balanced

What's included

• 1x XING2 1806 brushless motor 1.5mm shaft (KV is optional)
• 6x M2*7mm screws