iFlight iPower GM110-8 Gimbal Motor w/ AS5048A Encoder / Alexmos 32BIT BGC set
by iFlight
Sold out
Original price
$0.00
-
Original price
$0.00
Original price
$0.00
$1,210.00
$1,210.00
-
$1,210.00
Current price
$1,210.00
free return
Do you live in Belgium or The Netherlands? Then you can return your package for free!
Out of stock
Description
Description
Characteristics
- Encoders are special sensors that are added to each brushless motor of a Gimbal stabilizer, allowing the system to more accurately track motor position for greater stability, which in turn also increases battery efficiency.
- What is encoder technology in brushless gimbal control system?
- The 3-axis gimbal stabilization system that relies on both active motor-driven components and passive inertial stabilization. Passive stabilization is based on the principles of inertia (the tendency of an object to resist change in its motion) and requires the camera to be well balanced in the Pan, Tilt and Roll axes. Active stabilization refers to the techniques of using sensors to measure the Pan, Tilt and Roll movements of the camera and counter these movements using motors attached to the 3 axes.
Characteristics
- Easy to do gimbal tuning, no need to calibrate much anymore.
- Energy saving, 5 times long working time than gimbal without encoder system.
- Dual IMUs.
- Faster response, motor torque increases instantly, no more bug for difficult turning angle.
- Encoderchip A5048a
| Model | GM110-8 |
| Engine Outer Diameter | Ф110±0.05mm |
| Engine Height | 33.9±0.2mm (including Encoder Housing) |
| Hollow shaft (OD) | N/A |
| Hollow axis (ID) | N/A |
| Wire length | 610±3mm |
| AWG cable | #24 |
| engine weight | 610±3g |
| Wire connection | 2.5mm dupont connector |
| No load current | 20V |
| No load voltage | 0.09±0.1 A |
| No load RPM | 125~139 RPM |
| Load current | 20V |
| Load voltage | 2a |
| Load torque (g) | 8000-12000 |
| Internal motor resistance | 20.19Ω±5% (resistance varies with temperature) |
| High voltage test | DC500V 1mA @2sec |
| Rotor housing tread | ≤0.1mm |
| Direction of rotation (shaft extension) | clockwise |
| High-low temperature test | |
| High temperature | 60℃ for 100 hours, and the motor can work normally after 24 hours at room temperature |
| Low temperature | -20℃ for 100 hours, and the motor can work normally after 24 hours at room temperature |
| Maximum power | ≤60W |
| Work flow | 4-6S |
| Working temperature | -20~60℃;10~90%RH |
What is included
- 3 x GM110-8 gimbal motor with AS5048A encoder and magnet
- 1 x Alexmos 32BIT BGC Board Encoder Version without Aluminum Case
- 1x Set of connection cables