Skip to content
FAQ Contact Order Tracking Affiliate
|<none>|1005002939921335

iFlight iPower GM6208-150T Gimbal Motor w/ AS5048A Encoder /Alexmos 32BIT BGC set

by iFlight
Sold out
$0.00 - $0.00
$0.00
$739.00
$739.00 - $739.00
$739.00

free return

Do you live in Belgium or The Netherlands? Then you can return your package for free!

Out of stock
Description
Description
  • Encoders are special sensors that are added to each brushless motor of a Gimbal stabilizer, allowing the system to more accurately track motor position for greater stability, which in turn also increases battery efficiency.
  • What is encoder technology in brushless gimbal control system?
  • The 3-axis gimbal stabilization system that relies on both active motor-driven components and passive inertial stabilization. Passive stabilization is based on the principles of inertia (the tendency of an object to resist change in its motion) and requires the camera to be well balanced in the Pan, Tilt and Roll axes. Active stabilization refers to the techniques of using sensors to measure the Pan, Tilt and Roll movements of the camera and counter these movements using motors attached to the 3 axes.

Characteristics
  • Easy to do gimbal tuning, no need to calibrate much anymore.
  • Energy saving, 5 times long working time than gimbal without encoder system.
  • Dual IMUs.
  • Faster response, motor torque increases instantly, no more bug for difficult turning angle.
  • Encoderchip A5048a

iPower Motor GM6208 brushless gimbal motor
  • iPower Motors' GM62 series motor is the ultimate brushless gimbal motor for DSLR/CANON 5D MARKII, MARKIII cameras. This motor is designed for large-scale multi-rotor platforms that want to lift Red Epic and DSLR sized gears - 4 kg/cm of torque. The principle of camera stabilization using direct drive brushless motors. In fact, the gimbal based on BLDC motors is very similar to the common gimbal based on hobby servo.
Model GM6208
Engine Outer Diameter Ф69.5±0.05mm
Engine Height 32±0.2mm (Including Encoder Housing)
Hollow Shaft (OD) Ф25-0.01/-0.015 mm
Hollow Shaft (ID) Ф22+0.05/+0 mm
Wire length 610±3mm
AWG cable #24
engine weight 265±0.5g
Wire connection 2.5mm dupont connector
Current without load 20V
Voltage without load 0.08±0.1 A
RPM without load 209~231 RPM
Current on load 20V
Voltage under load 1.2A
Load Torque(g) 2600-3600
Motor internal resistance 32Ω±5% (Resistance varies with temperature)
High voltage test DC500V 1mA @2sec
Rotor housing outlet ≤0.1mm
Steering direction (axle extension) clockwise
High-low temperature test
High temperature Keep at 60℃ for 100 hours and the motor can work normally after 24 hours at room temperature
Low temperature Keep at -20℃ for 100 hours and the motor can work normally after 24 hours at room temperature
Maximum power ≤25W
Work flow 3-5S
Working temperature -20~60℃;10~90%RH

 

What is included

  • 3 x GM6208 150T Gimbal Motor with AS5048A Encoder and Magnet
  • 1 x Alexmos 32BIT BGC Board Encoder Version without Aluminum Case
  • 1x Set of connection cables